DAV II 2-Stage PM VSD Energy Efficient Compressor
90-3137 [cfm]; 2.54-88.35 [m3/min]
7-12.5 [bar]; 102-181 [psig]
55-400 [kw]; 75-550 [hp]
DENAIR DAV II 2-Stage PM VSD Energy Efficient Compressor
Download
For more information about certifications, please contact us.>
- Low Frequency Operation
- Speed Control System
- High Efficiency
- Stable Pressure
Performance advantages of DAV II 2-Stage PM VSD Energy Efficient Compressor:
-
Low Frequency Operation
Ultra-low temperature rise design, which allows the compressor running at ultra-low frequency for a long time.
-
Speed Control System
Closed-loop vector control system for faster control and more precise speed control.
-
High Efficiency
The compressor unit can still operate efficiently when the frequency is reduced by more than 50%.
-
Stable Pressure
The pressure is stable and the pressure fiuctuation is accurately controlled within 0.1 bar.
-
Control Module
· RS485 communication mode transmission control signal
· Intelligent PID flow adjustment mode
· Closed-loop control, with ideal dynamic characteristics and control accuracy
· Accurately control the torque
· Fast response speed
· Constant pressure control to avoid excess energy loss -
Air End
· The rotor adopts the world's leading high-efficiency profile and is made of 1141 special steel, which has good hardness and high wear resistance.
· Two-stage independent compression, low-speed design, lower overall noise.
· The low compression ratio at each stage ensures smaller leakage and higher volumetric efficiency.
· Oil mist spray cooling is used between stages, and the compression process is close to isothermal compression to improve efficiency.
· The rotor and bearings are under little stress, and the long life of screw element is guaranteed to continue running.
· Under the set frequency conversion pressure, the unit will automatically adjust to keep the output pressure within ±0.1 bar, reducing unnecessary waste (the power consumption increases by 7% for every 1 bar of pressure increase) -
Permanent Magnet Motors
· High efficiency: Eliminates excitation system losses and improves efficiency.
· It is still efficient under low load conditions: the energy efficiency of a permanent magnet motor is more than 9% higher than that of a conventional asynchronous motor at full load operation, and its energy efficiency remains unchanged as the speed decreases.
· Large overdrive torque: The ratio of the maximum starting torque of the permanent magnet synchronous motor to the rated torque can be more than 3 times, while the general asynchronous motor is only 1.6 times.
· The control is more stable: the corresponding time of the permanent magnet motor is <50ms, and the gas production can be adjusted in a large range in an instant, so that the gas pressure is truly stable. -
Inverter
· High utilization rate, removable panel, switch using, memory function
· Protection: can realize phase loss, phase-to-phase short circuit, short-circuit to ground, over-current, over-voltage, under-voltage, overload, over-heat, motor thermal protection circuit board, reinforced coating, dust and corrosion protection
· Independent cooling design, suspended installation, dust proof, corrosion proof, small heat, powerful overload and unique current limiting technology
· Proprietary and efficient control procedures
· Ultra-wide frequency design, wider control range -
Air Filter Assemblage
The imported brand is used to reliably remove dirt from the air. The dust particles in the air are controlled below 0.3 microns and the filtration accuracy is as high as 99.99%.
-
Oil Filter
The imported brand is used to reliably filter the dirt particles in the lubricating oil to ensure the smoothness and lubrication of the oil system at 0.1 micron.
-
ADNOC - Oil & Gas Giant in UAE
Continuous air supply, safety, and high-efficiency operation are critical for the oil...
Read More > -
KDC - Offshore Drilling Platform
Kuwait Drilling Company K.S.C (KDC) was established in 1963, and became a joint vent...
Read More > -
Skid Diesel Compressor for HP Drilling
High-pressure diesel air compressor such as 25, 30, and 35 bar is mainly used for var...
Read More >
Click For More Projects >
